Symptom

Refrigerator not coolingbut the freezer is fine

The short answer

A warm refrigerator with a cold freezer is an air problem, not a compressor problem. The cold freezer proves the sealed system works. That leaves the evaporator fan ($150 to $350), a frosted up coil behind the freezer wall ($180 to $400) or a stuck damper, which is the cheap end of the list.

A technician crouched beside a chest freezer pulled away from the wall, holding a small black cylindrical component.

What to check, in order

Free checks first. The cheap causes are also the common ones.

Listen at the freezer for the fan

Open the freezer and hold the door switch in with your thumb. On most refrigerators one evaporator in the freezer cools both sides, and a fan blows that cold air across to the fresh food section. No fan noise with the switch held in is very often the whole fault.

Look for frost on the freezer back wall

A sheet of ice over the back panel means the defrost system has quit and the coil has iced up. Air cannot get through ice, so the freezer stays cold and the fresh food side warms up. The defrost heater or thermostat runs $180 to $400.

Check the vents inside the fridge

There is a vent at the top rear of the fresh food section where the cold air comes in. A stack of containers pushed up against it does this on its own, and moving them takes ten seconds.

Check the damper

Some models meter cold air through a damper you can see inside the fresh food section, usually near that vent. Make sure nothing in the refrigerator has knocked it shut.

Where to stop

All three of those parts sit behind the rear panel of the freezer. The panel has to come out, and sometimes it has to be thawed first. That is the point to call. Tell us the freezer is still cold, because it narrows the job a long way before anyone arrives. Move the food into the freezer side or a cooler while you wait, because the fresh food section is not holding a safe temperature.

  • Behind a panel there are live terminals, sharp edges and sometimes a sealed refrigerant circuit.
  • Replacing a part you guessed at is the expensive way to diagnose. A meter settles in a minute what a parts order settles in a week.
  • If the machine is inside a manufacturer warranty, opening it yourself can end that cover.
  • A burning smell or a scorched connector means stop, unplug it and leave it.

What the repair runs if it is not a free fix

PartTypical range
Start relay or overload protectorOne of the two cheap failures worth ruling out first on a unit that is not cooling$120 to $250
Condenser or evaporator fan motorThe other one. A clicking every few minutes points here or at the relay$150 to $350
Defrost heater or thermostatHeavy frost on the back wall, or a unit that cools then warms$180 to $400
Thermistor or temperature sensorRunning constantly without reaching temperature$130 to $280
Door gasketVaries most by model; a built in gasket costs far more than a freestanding one$150 to $400
Electronic control boardThe modern cost driver. A mechanical predecessor was a fraction of this$350 to $700
Compressor or sealed systemThe one real cliff. Opening the refrigerant circuit is a different class of job and is quoted on its own$700 to $1,800

For comparison, a replacement typically runs $900 to $2,600 installed, which is the figure to compare against rather than the shelf price.

Questions people ask

What counts as urgent and what can wait?

Rank it by what the fault is costing you while it sits there. A burning smell or a scorched plug means unplug it and stop using it, whatever else is going on. Say on the phone whether there is water on the floor or food at risk.

Which refrigerator brands are easiest to get parts for?

Whirlpool, GE, Maytag, Frigidaire and LG cover most kitchens around here, and parts for all of them are current. LG and Samsung front loaders from the same era share a drain pump fault, and that part is a stock item. The model number answers this. Have it ready.

How much does refrigerator repair cost?

The honest answer is a range. The same symptom can have a cheap cause or an expensive one. A thermostat, a door switch, a drain pump or a fan motor sits at the cheap end. A control board sits in the middle. A sealed system or a compressor is its own job and gets quoted on its own. Ask for the price first, then decide whether to go ahead.

Related questions

Whether a washing machine is worth repairingMost washer repairs are worth doing, because the parts that usually fail run $140 to $400.Repair or replace a refrigeratorRepair it if the sealed system is sound and the part is still made.Repair or replace an appliance in an older houseIn an older house this is a fit question before it is an appliance question.

Past the free checks?

Call with the model number and the list of what you already tried.

(716) 414-5233
Call (716) 414-5233