What goes wrong, which part it usually is, and what moves the price.
$140 to $650Typical for the part plus the labor to fit it. Drum bearing or outer tub is a different class of job and is quoted on its own.
Any washer repair is two jobs: finding out what broke, and the part to fix it. Most of the time the part that failed is a cheap one, so a tech checks those first.

The part sets the price, not the appliance and not where you live. Have the model and serial number off the sticker when you call. Two machines with the same name on the door can take different parts, and the sticker is the only thing that tells us which.
| Part | Typical range |
|---|---|
| Drain pumpNearly always the cause of a machine that will not drain | $180 to $400 |
| Lid or door lock switchThe usual reason a washer will not spin or will not start | $140 to $300 |
| Drive belt or motor couplerWill not spin, or spins without agitating | $150 to $350 |
| Water inlet valveWill not fill, or fills slowly | $150 to $320 |
| Water level or pressure sensorStopping mid cycle, or overfilling | $160 to $350 |
| Suspension rods or dampersWalking across the floor on spin, where levelling has not fixed it | $200 to $450 |
| Main control boardDiagnosed last, because a cheaper sensor usually explains the same symptom | $300 to $650 |
| Drum bearing or outer tubFrequently the point at which a replacement becomes the better value | $600 to $1,200 |
For comparison, a replacement typically runs $700 to $1,600 installed, which is the figure to compare against rather than the shelf price.
Write down what the machine is doing, in your own words, before you call. Find the power and water shut offs before the appointment rather than during it. Call once you have the model number in front of you.
Some faults cost you money every hour they sit. Those are the urgent ones. A full freezer holds its cold for roughly a day with the door kept shut. A warm fridge gives you a few hours of safe food and no more. Lead with the water or the food when you call, not with the brand.
Older machines were built to be opened up, and that counts for a lot. Rebuilt and salvaged boards exist for some models, and they can keep a sound machine running. Ask whether that exact part is still available for your model.
Try the cheap checks. Stop at the point where a panel has to come off. Clean the filters. A blocked dishwasher filter, a clogged dryer vent and a jammed washer pump filter all look like a dead machine. Try the short list, then call and tell us what you found.
Brand matters less than people expect, and parts supply matters more. The sticker settles it. Two machines with the same name on the door can take different parts. Have the model and serial ready and ask about the exact part.
A repair bill is two things: the visit that finds the fault, and the part that fixes it. Electronic controls are the modern cost driver. The mechanical timer they replaced was cheap. The board is not. Ask for the price of the repair before any work starts.