These two symptoms travel together, because a washer that cannot drain will refuse to spin. Start with the pump filter and the drain hose, which are free to check, and after that it is the drain pump ($180 to $400), the lid or door lock switch ($140 to $300) or the belt or motor coupler ($150 to $350).

Free checks first. The cheap causes are also the common ones.
Most front loaders have a small hatch at the bottom front with a filter behind it. Put towels and a shallow pan down first, because the drum is still full of water. A sock, a coin or a hair clip in there stops the pump dead, and clearing it is free.
A washer will not spin while it believes the lid is open. Listen for the click as the lid or door shuts. No click, or a latch that does not catch, and the switch is the likely fault at $140 to $300.
Look behind the machine where the hose loops up to the standpipe. A kink there gives you the same symptom as a dead pump and takes a second to straighten out.
If it stopped draining and then stopped spinning, the drain is the fault. If it drains fine and simply will not spin, look at the lid switch, the belt and the motor coupler instead. Tell us which way round it happened.
Past the filter and the lid switch, the pump, the belt, the coupler and the control board all mean opening a machine with a tub of water still in it. That is the point to call, and say there is standing water, because it changes what gets brought to the job. Do not keep running cycles to see if it clears on its own: a pump straining against a blockage is how a free fix turns into a $180 to $400 pump.
| Part | Typical range |
|---|---|
| Drain pumpNearly always the cause of a machine that will not drain | $180 to $400 |
| Lid or door lock switchThe usual reason a washer will not spin or will not start | $140 to $300 |
| Drive belt or motor couplerWill not spin, or spins without agitating | $150 to $350 |
| Water inlet valveWill not fill, or fills slowly | $150 to $320 |
| Water level or pressure sensorStopping mid cycle, or overfilling | $160 to $350 |
| Suspension rods or dampersWalking across the floor on spin, where levelling has not fixed it | $200 to $450 |
| Main control boardDiagnosed last, because a cheaper sensor usually explains the same symptom | $300 to $650 |
| Drum bearing or outer tubFrequently the point at which a replacement becomes the better value | $600 to $1,200 |
For comparison, a replacement typically runs $700 to $1,600 installed, which is the figure to compare against rather than the shelf price.
Repair wins most of the time, as long as the tub, the drum and the cooling system are still good. Saving on energy is real but slow. It rarely catches up with a repair that costs a fraction of a new unit. Ask whether the part is still made before you decide either way.
Start with the power, the door switch and the filters. Those three explain a lot of dead appliances. If the machine has a reset, use it once. If the fault comes straight back, the reset was not the answer. Try the short list, then call and tell us what you found.
A repair bill is two things: the visit that finds the fault, and the part that fixes it. Sealed system work is the one real cliff. Opening the refrigerant circuit is a different class of job from swapping a switch. Ask for the full price, parts and labor together, not just the part.
Call with the model number and the list of what you already tried.
(716) 414-5233