On a dryer that turns but will not heat, check the vent before anything else. A blocked vent makes the dryer overheat, which blows the thermal fuse ($120 to $260) or burns out the heating element ($180 to $400), and replacing either one without clearing the vent just breaks the new part.

Free checks first. The cheap causes are also the common ones.
Pull the dryer out and take the duct off the back, then check the full run to the hood outside. The lint that causes this collects in the duct and at the hood, where you cannot see it from inside the laundry room.
In winter the flap ices over or gets banked in with snow. That gives you exactly the same symptom as a dead heating element and costs nothing to fix.
An electric dryer runs on two legs of power. If one leg trips, the drum still turns and the heat does not. Switch the breaker fully off and back on before you assume a part has failed.
Electric points at the heating element, the thermal fuse or the cycling thermostat. Gas points at the igniter or the gas valve coils, which run $180 to $420. Same symptom, different part, different job.
Past the vent and the breaker, the element, the fuse and the igniter all sit behind a panel with live terminals, and a gas dryer has a gas connection back there as well. Gas work is never a DIY job. That is the point to call. Waiting is not neutral here either: every cycle on a blocked vent packs more lint into the duct, and lint in a hot duct is how dryer fires start.
| Part | Typical range |
|---|---|
| Heating elementRuns but will not heat, on an electric dryer | $180 to $400 |
| Thermal fuse or cycling thermostatCheck before the element. A blown fuse is frequently a symptom of a blocked vent rather than a fault | $120 to $260 |
| Igniter or gas valve coilThe gas dryer equivalent of a failed element | $180 to $420 |
| Drum rollers, idler pulley or beltSquealing, rumbling or thumping | $180 to $400 |
| Rear drum bearingA deeper noise than the rollers, and a longer job | $250 to $500 |
| Moisture sensorShutting off early on an auto dry cycle | $140 to $300 |
| Door switch or start switchWill not start at all | $120 to $260 |
| Blower wheelPoor airflow where the vent is already clear | $180 to $380 |
For comparison, a replacement typically runs $650 to $1,500 installed, which is the figure to compare against rather than the shelf price.
Whirlpool, GE, Maytag, Frigidaire and LG cover most kitchens around here, and parts for all of them are current. A model dropped ten years ago often still has common parts available even when its control board does not. Ask what the part is and whether anybody still makes it.
An appliance built before control boards is often very repairable. The sticking point is a circuit board from a model that sold in small numbers, because nobody reproduces those. Ask whether that exact part is still available for your model.
The model number, what the machine is doing, and when it started. Those are the three. Pull the unit out if it moves easily. If it does not, say so, because a built in is a different job. Have the model number ready and tell us what the machine is doing.
Call with the model number and the list of what you already tried.
(716) 414-5233